P1 Pwm 1/2 Max Speed; P2 Pwm Max Speed; P4 Elevation Min; P5 Elevation Max - Vision Fitness T9800S Engineering Manual

DGF1J Upper Board: Engineering Guide
3.4 MANUAL CALIBRATION
MANUAL CALIBRATION MENU
• P0 PWM Minimum Speed
• P1 PWM 1/2 Maximum Speed
• P2 Maximum Speed
• P4 Elevation Minimum
• P5 Elevation Maximum
• P13 Elevation Direction
• P19 Magnet Count
• P20 Effective Diameter
• P21 PWM Start Speed
• P29 Ramp Time
• Exit
Key Function
ENTER Selects Menu Item or saves value
ELEVATION UP Next Menu Item
ELEVATION DOWN Previous Menu Item
SPEED UP Increments Value
SPEED DOWN Decrements Value
STOP Returns to menu
START N/A
3.4.1 P0 PWM MIN SPEED
PWM minimum speed is the PWM when the belt is the minimum speed (0.5 MPH/0.4 KPH). This setting is used to
calibrate the PWM output to the motor controller.

3.4.2 P1 PWM 1/2 MAX SPEED

PWM at half the maximum speed (12.0 MPH). This setting is used to calibrate the PWM output to the motor controller.

3.4.3 P2 PWM MAX SPEED

PWM at maximum speed (12.0 MPH), used to calibrate the PWM output to the motor controller.

3.4.4 P4 ELEVATION MIN

Current elevation minimum value is displayed in the Speed window.
CAUTION!!! THERE IS NO MECHANICAL STOP OR LIMIT SWITCH TO LIMIT ELEVATION UPWARD
TRAVEL. CARE MUST BE TAKEN TO PREVENT RUNNING THE ELEVATION MOTOR OFF THE "TOP".

3.4.5 P5 ELEVATION MAX

Current elevation maximum value is displayed in the Speed window.
TREADMILL.UPPERBDENG.DGF1J.CVTM0033.CVTM0031.REV2
19
Date of last revision: 11.06