Elevation Burn-In Test - Vision Fitness T9800S Engineering Manual

DGF1J Upper Board: Engineering Guide

3.2.7 ELEVATION BURN-IN TEST

The elevation burn-in test continually runs from minimum elevation to maximum elevation.
Key Function
ENTER Starts test
ELEVATION UP N/A
ELEVATION DOWN N/A
SPEED UP N/A
SPEED DOWN N/A
STOP Stops Test, returns to test menu
START N/A
Display Function
Dot Matrix # up/down cycles
Alphanumeric Displays "ELEVATION BURN-IN TEST"
Elevation Elevation a/d ticks
Speed Target Elevation in % Grade
3.2.8 EXIT
Press the key to return to the main Engineering Mode menu.
"ENTER"
3.3 AUTO-CALIBRATION
The Auto-Calibration routine automatically finds and sets the start, minimum, half-maximum and maximum PWM values
and the maximum and minimum elevation values. Success or failure of the auto calibration routine will be temporarily
indicated in the alphanumeric display upon completion of the auto calibration routine. Exits Engineering Mode at completion.
See Section 4.7 for details.
CAUTION!!! BELT WILL START TO MOVE UNDER SOFTWARE CONTROL WITH NO RAMPING!!!
TREADMILL.UPPERBDENG.DGF1J.CVTM0033.CVTM0031.REV2
17
Date of last revision: 11.06