System Calibration Procedure; Enter Engineering Mode; Set Elevation Direction; Set Elevation Minimum - Vision Fitness T9800S Engineering Manual

DGF1J Upper Board: Engineering Guide

4. SYSTEM CALIBRATION PROCEDURE

Before initial use or after a NOVRAM reset, the system will need to be calibrated. The following procedures outline
the calibration procedures.
CAUTION! MANY CALIBRATION PROCEDURES CAUSE BELT MOVEMENT WITHOUT RAMPING.
DO NOT STAND ON THE BELT OR IN ANY POSITION THAT COULD BE COMPROMISED BY BELT
OR ELEVATION MOVEMENT!

4.1 ENTER ENGINEERING MODE

1. Hold down the
"ELEVATION UP"
alphanumeric.
2. Press the
"ELEVATION UP"
3. Press the
"ENTER"

4.2 SET ELEVATION DIRECTION

Elevation direction adjustment allows the same console software to be used with a reversed configured elevation motor
and the AC Motor Controller.
1. Press
"ELEVATION UP"
2. Press , the value (" " Y Y E E S S " " or " " N N O O " " ) in the speed window will blink.
"ENTER"
3. Using the
"SPEED UP/DOWN"
Controller.
4. Press the
"ENTER"

4.3 SET ELEVATION MINIMUM

Adjusts elevation minimum setting.
1. Press the
"ELEVATION UP/DOWN"
2. Press the
"ENTER"
3. Adjust the treadmill to the lowest position using the
displayed in the elevation window)
4. Press the
"ENTER"

4.4 SET ELEVATION MAXIMUM

Adjusts elevation maximum setting.
1. Press the
"ELEVATION UP/DOWN"
2. Press the
"ENTER"
3. Adjust the treadmill to the highest position using the
THE ELEVATION DRIVE OFF THE UPPER END OF TRAVEL! (Elevation A/D reading displayed in the
elevation window)
4. Press the
"ENTER"
TREADMILL.UPPERBDENG.DGF1J.CVTM0033.CVTM0031.REV2
and
"SPEED DOWN"
key until " " M M A A N N U U A A L L C C A A L L I I B B R R A A T T I I O O N N " " is displayed in the alphanumeric
key. " " P P 0 0 P P W W M M M M I I N N S S P P E E E E D D " " will be displayed in the alphanumeric.
key 5 times until, " " P P 1 1 3 3 E E L L V V D D I I R R E E C C T T I I O O N N " " is displayed.
keys select either " " Y Y E E S S " " for the AC Motor Controller or " " N N O O " " for the DC Motor
key to save or the
"STOP"
keys until " " P P 4 4 E E L L E E V V A A T T I I O O N N M M I I N N " " is displayed in the alphanumeric display.
key.
key to save or the
"STOP"
keys until " " P P 5 5 E E L L V V A A T T I I O O N N M M A A X X " " is displayed in the alpha-numeric display,
key.
key to save or the
"STOP"
23
keys until " " E E N N G G I I N N E E E E R R I I N N G G M M O O D D E E " " is displayed in the
key to retain the previous value.
keys. (Elevation A/D reading
"SPEED UP/DOWN"
key to retain the previous value.
keys CAUTION! DO NOT RUN
"SPEED UP/DOWN"
key to retain the previous value.
Date of last revision: 11.06