Advertisement
CALL 1-800-577-8111 FOR SALES AND SUPPORT
EPD, EPPD
Materials Needed
• PVC or ABS pipe cement (read manufacturer's instructions carefully)
• PVC or ABS pipe;
– 1
/
" for EPPD-3 & EPD-3
1
4
– 1
1
/
" for EPD-5,7,10 & 15
2
• PVC adapter
– 1
1
/
" for EPPD-3 & EPD-3
4
– 1
1
/
" for EPD-5, 7, 10 & 15
2
• In line check valve
• Sump basin 18" or larger diameter plastic, fiberglass or concrete.
(See page 2 for minimum diameter basin size by pump capacity.)
• Optional: gate valve
(see installation drawing on page 6)
Installation Instructions
Step 1 Inspection: Your pump has been carefully packaged to prevent damage during
shipping. However, occasional damage does occur due to rough handling. Carefully
inspect the pump for damage that could cause it to fail.
Step 2: Attach desired length of PVC or ABS discharge pipe to pump outlet, using PVC
adapter (1
/
" pipe and adapter for EPPD-3 & EPD-3 1
1
4
sure open end of pipe will be above top of basin.
Step 3: Clear sump basin of any water, debris or sediment.
Step 4: Lower pump into basin.
Step 5: Attach in line check valve to discharge pipe 12" to 18" above pump discharge
with arrow pointing away from the pump (with the flow). Connect other end of check
valve securely to drain pipe and tighten clamps.
Note: Do not put check valve directly into pump discharge opening.
Step 6: Drill a 1/8" relief hole in the discharge pipe 5" above pipe connection to pump.
Step 7: Plug in pump and fill sump basin with water to test unit. Pump should turn on at
13" to 14" water level. Allow pump to go through several ON-OFF cycles to assure satis-
factory operation.
Note: If pump does not operate properly, see the troubleshooting checklist on page 12.
Septic Tank Installation
The PRO•DRAINER pumps can be used to pump septic tank effluent, but must be
installed as follows:
• Install pump in separate compartment at the discharge side of the septic tank. Never
install pump in main tank where sludge collects.
• Use with a junction box.
WARNING: Sump basin must be vented in accordance with local plumbing codes.
These pumps are not designed for and CANNOT be installed in locations classified as
hazardous in accordance with the National Electric Code, ANSI/NEPA 70-1984.
CALL 1-800-577-8111 FOR SALES AND SUPPORT
/
" for EPD-5, 7, 10 & 15). Make
1
2
Advertisement
