Advertisement
CALL 1-800-577-8111 FOR SALES AND SUPPORT
EPD, EPPD
To reduce risk of injury, always follow these instructions and safety precautions
when using this pump and to maintain warranty.
Read All Instructions Prior to Installation
Installation/Operation:
• Never lift or carry pump by the electrical cord. Use a chain or rope affixed
on handle to install/remove pump. To reduce potential damage to the pump
from inadvertent lifting by the electrical cord, please refer to "Proper Lifting"
located on the following page.
• This pump must be operated fully submerged. Pump must be shutdown if
sump, pit or pond level drops below the motor housing.
• Pump is designed to pump clean water (maximum temperature of 122
with suspended solids up to 3/16 of an inch. Larger solids will clog the
suction strainer plate leading to dry running and subsequent failure ( Note:
Pumping sand, gravel, and other hard debris will shorten the life of the
pump) . Elevate the pump with bricks or other support above the sump, pit or
pond bottom if debris is present. Consult dealer for other fluids.
• Clean filter basin when cleaning inlet filter media when pump is shutdown.
• If used with a float switch, the float must have a full range of motion to
operate properly without obstruction. Consult dealer for minimum dimensions
required for proper float operation.
• Pump should be mounted upright only (vertical). Never lay the pump on its side.
Electrical Requirements:
• Pump must be operated with a GFI breaker of at least 20 amps.
• High OR Low Voltage can damage the pump. Power from your utility or generator
set cannot be more or less than 10% of the rated voltage on the pump.
• Maximum distance from power source and pump must not exceed 100 feet
using 16/3 electrical cables. This distance is from the breaker box and
includes the pump cord. If the run is longer, consult a qualified electrician or
your dealer.
• Lightning strikes can destroy the capacitor in your pump. Ensure proper
protection is provided.
• Consult operator manual for other operation and application information.
CALL 1-800-577-8111 FOR SALES AND SUPPORT
Important Safeguards
(SAVE THESE INSTRUCTIONS)
• •
F)
Advertisement
