Installing The Reactor Box - JUKI DDL-9000C-S Instruction Manual

2-8-3. Installing the reactor box

* For the EU-type models, install the reactor box that is supplied with the sewing machine.
❸
❽
❼
❾

❼

Undersurface of table
Power box
SC-950(951)
❷
❹
❺
❶
❸
❽
❶
❾

Operator's side
❼

❶
1) Connect the terminals of power cord ❶ of the
SC-950(951) to reactor-box PCB asm. ❷ and
to reactor box mounting plate ❸.
Connect brown wire A to the first connector
A
and blue wire B to the third connector respec-
tively from the top of terminal block on the
C
B
reactor box PCB asm. using screws. Connect
❻
green/yellow wire C to reactor box mounting
plate ❸ with earth setscrew ❹.
2) Attach cable clip ❺ to the power cord of SC-
950(951). Attach the power cord together with
the cable clip to reactor box mounting plate ❸
❽
with cable clip setscrew ❻.
3) Attach cord bushes ❽ to input/output cables
❶ and ❼ of the reactor box. Attach both bush-
es in the same manner.

4) Attach reactor box cover  to reactor box
mounting plate ❸ with four reactor-box cover
setscrews ❾.
At this time, fix cord bushes ❽ attached to
input/output cables ❶ and ❼ in the concave
section on reactor box cover  to eliminate a

gap between reactor box  and cover .
5) Install reactor box  on the table stand with
four accessory wood screws  at the position
that is approximately 200 mm away from the
front end of table stand.
Adjust the installing position according to the
size of table stand so that the reactor box does
not protrude from the edge of table stand.
6) Fix input/output cables ❶ and ❼ of reactor
box  on the table stand using accessory cord
staple .
At this time, take care not to cross the input-
and output-cables.

– 8 –