External Interface; Usb - JUKI DDL-9000C-S Instruction Manual

8-9. External interface

8-9-1. USB

(1) About the USB
Sewing data, custom pitch data and condensation custom data can be copied on a commercially-avail-
able USB thumb drive.
Refer to "8-7-2. Communication function" p.100
USB thumb drive.
① Position of the USB connector
② Precautions to be taken when handling USB devices
• Do not connect to the USB connection terminal other than the USB memory.
It may cause failure.
• Do not leave the USB device or USB cable connected to the USB port while the sewing machine is
in operation. The machine vibration can damage the port section resulting in loss of data stored on
the USB device or breakage of the USB device or sewing machine.
• Do not insert/remove a USB device during reading a program or sewing data.
It may cause data breakage or malfunction.
• When the storage space of a USB device is partitioned, only one partition is accessible.
• Never forcefully insert a USB thumb drive into the USB connector while carefully checking the ori-
entation of the USB thumb drive. Forceful insertion of the USB thumb drive can cause failure.
• JUKI does not compensate for loss of data stored on the USB device caused by using it with this
sewing machine.
• In principle, connect only one USB thumb drive to the operation panel. When two or more devic-
es/media are connected/inserted, the machine will only recognize one of them. Refer to the USB
specifications.
• Do not turn the power OFF while the data on the USB flash drive is being accessed.
③ USB specifications
• Conform to USB 1.1 standard
• Applicable devices * 1 ��� USB memory
• Format supported ����� FAT 12, FAT 16, FAT 32
• Applicable medium size � 4.1MB ~ (2TB)
• Consumption current ��� The rated consumption current of the applicable USB devices is 500 mA
* 1 : JUKI does not guarantee operation of all applicable devices. Some device may not operate due to
a compatibility problem.
for details of how to copy the sewing data on a
❷
❶
at the maximum.
– 108 –
1. USB thumb drive insertion position
The USB connector is provided on top ❶ of
the operation panel.
To use a USB thumb drive, remove connec-
tor cover ❷ and insert the USB thumb drive
into the USB connector.
* In the case a USB thumb drive is not used,
the USB connector should be protected with
connector cover ❷ without exceptions.
If dust or the like enters the USB connector,
a failure can be caused.