Reverse Feed Stitching (At Start) Pattern - JUKI DDL-9000C-S Instruction Manual

4-2-2. Reverse feed stitching (at start) pattern

A stitch shape of the reverse feed stitching (at start) is set by following the steps of procedure described
below.
(1) Enabling the reverse feed stitching (at start) pattern
(2) Changing the number of stitches and pitch of reverse feed stitching (at start) pattern
① Displaying the edit screen for reverse feed stitching (at start)
<Edit screen for reverse feed stitching (start)>
② Setting the shape, the number of stitches and pitch of reverse feed stitching (at start)
Type of stitch Edit item
❸
A
❸
❶ ❷
– 31 –
In the state pictograph A is displayed on
the screen, the reverse feed stitching (at
start) is enabled.
If pictograph A is not displayed on the
❸ to display it to en-
screen, press
able the reverse feed stitching (at start).
❸ held pressed for one sec-
Keep
ond. The reverse feed stitching (at start)
edit screen is displayed.
Select the type of stitch with
Select the edit item of the reverse feed
stitching (at start) with
After the selection of the edit item, change
the numeric value with
❷ .
❶ .
❷ .