Configuration And Image Commands - 3Com 3800 User Manual

Table 4-18 Logging Commands (continued)
Command
config syslog <ipaddress> <facility>
{<priority>} {<subsystem>}
enable log display
enable syslog
disable log display
disable syslog
Configuration and
Image Commands
Table 4-19 Configuration and Image Commands
Command
save {config} {primary | secondary}
use config {primary | secondary}
use image {primary | secondary}
(continued)
Table 4-19 describes configuration and image commands.
Switch 3800 Commands
Description
Allows you to configure the syslog host address and
filter messages sent to the syslog host. Options include:
ipaddress — The IP address of the syslog host.
facility — The syslog facility level for local use.
priority — Filters the log to display message with the
selected priority or higher (more critical). Priorities
include critical, warning, and informational. If not
specified, only critical priority messages are sent to
the syslog host.
subsystem — Filters the log to display messages
associated with the selected Switch subsystem.
Subsystems include Syst, STP Brdg, SNMP, Telnet,
VLAN, and Port. If not specified, all subsystems are
sent to the syslog host.
Allows you to enable the log display.
Allows you to enable logging to a remote syslog host.
Allows you to disable the log display.
Allows you to disable logging to a remote syslog host.
Description
Allows you to save the current configuration of the
Switch to NVRAM. You can specify the primary or
secondary configuration area. If not specified, the
configuration is saved to the configuration area
currently in use.
Allows you to configure the Switch to use a particular
configuration on the next reboot. Options include the
primary configuration area, the secondary
configuration area, or an imported ASCII file. If not
specified, the Switch will use the primary configuration
area.
Allows you to configure the Switch to use a particular
image on the next reboot. If not specified, the Switch
will use the primary image.
4-23