3Com 3800 User Manual page 75

Table 4-17 RIP Commands (continued)
Command
enable rip exportstatic
disable rip exportstatic
config rip updatetime {<delay>}
config rip routetimeout {<delay>}
config rip garbagetime {<delay>}
config rip txmode [none | v1only | v1comp
| v2only] {vlan <name> | all}
config rip rxmode [none | v1only | v2only
| any] {vlan <name> | all}
unconfig rip {vlan <name> | all}
Description
Allows you to enable the advertisement of static
routes using RIP. The default setting is enabled.
Allows you to disable the filtering of static routes.
Allows you to change the periodic RIP update timer.
The default setting is 30 seconds.
Allows you to configure the route timeout. The default
setting is 180 seconds.
Allows you to configure the RIP garbage time. The
default setting is 120 seconds.
Allows you to change the RIP transmission mode for
one or more VLANs. Specify:
none — Do not transmit any packets on this
interface.
v1only — Transmit RIP version 1 format packets to
the broadcast address.
v1comp — Transmit version 2 format packets to the
broadcast address.
v2only — Transmit version 2 format packets to the
RIP multicast address.
If no VLAN is specified, the setting is applied to all
VLANs. The default setting is "v2only".
Allows you to change the RIP receive mode for one or
more VLANs. Specify:
none — Drop all received RIP packets.
v1only — Accept only RIP version 1 format packets.
v2only — Accept only RIP version 2 format packets.
any — Accept both version 1 and version 2 packets.
If no VLAN is specified, the setting is applied to all
VLANs. The default setting is "any".
Allows you to reset all RIP parameters to the default
VLAN. Does not change the enable/disable state of the
RIP settings.
Switch 3800 Commands 4-21