3Com 3800 User Manual page 47

Table 3-4 SNMP Configuration Commands
Command
config vlan <name> ipaddress <ip_address> {<mask>}
enable snmp access
enable snmp trap
config snmp add <ipaddress>
config snmp add trapreceiver <ipaddress> {<string>}
config snmp community [read | readwrite] <string>
config snmp delete [<ipaddress> | all]
config snmp delete trapreceiver [<ip_address> | all]
config snmp syscontact <string>
config snmp sysname <string>
config snmp syslocation <string>
Table 3-4 describes SNMP configuration commands.
Description
Configures an IP address for the VLAN. This is
required in order to use an SNMP manager.
Allows you to turn on SNMP support for the
Switch.
Allows you to turn on SNMP trap support.
Allows you to add the IP address of an SNMP
management station to the access list. Up to six
addresses can be specified.
Allows you to add the IP address of a specified
trap receiver. A maximum of six trap receivers is
allowed.
Allows you to configure the SNMP read and
write community strings. The community string
can have a maximum of 32 characters.
Allows you to delete the IP address of a specified
SNMP management station or all SNMP
management stations.
Allows you to delete the IP address of a specified
trap receiver or all authorized trap receivers. If
you delete all trap receiver addresses, any
machine can have SNMP management access to
the Switch.
Allows you to configure the name of the system
contact. A maximum of 32 characters is allowed.
Allows you to configure the name of the
Switch. The sysname appears in the command
line interface prompt. A maximum of 32
characters is allowed. The default sysname is
3C16910.
Allows you to configure the location of the
Switch. A maximum of 32 characters is allowed.
Using SNMP 3-11