Table of Contents
Advertisement
4-8
C
4: C
HAPTER
OMMANDS
Table 4-4 General Switch Commands (continued)
Command
config devicemode [bridging | iprouting] Allows you to configure the operating mode of the
unconfig switch {all}
ping {continuous} {size <number>}
<ipaddress>
traceroute <ipaddress>
clear counters
User Account
Commands
Table 4-5 User Account Commands
Command
show account
create account [admin | user] <username>
{<password>}
delete account <username>
config account <username> {<password>}
Table 4-5 describes user account commands.
Description
Switch. Specify:
bridging — Layer 2 bridging functions only
iprouting — Bridging and IP unicast routing
functions
If this command is used while the Switch 3800 is up
and running, the Switch saves the configuration and
reboots. The default operating mode is "iprouting."
Allows you to reset all Switch parameters (with the
exception of defined VLANs and IP addresses) to the
factory defaults. If you specify the keyword "all", the
IP addresses are reset as well.
Allows you to send ICMP echo messages to a remote IP
device. Specify:
continuous — ICMP echo messages should be sent
continuously.
size <n> — The size of the packet.
Allows you to trace the routed path between the
Switch and a destination endstation.
Allows you to clear all statistical counters for the Switch
and ports.
Description
Displays the account names, access level, number of
successful and failed logon attempts, and the number
of active sessions in the user database. This command is
available only to admin level users.
Allows you to create a user account.
Allows you to delete a user account.
Allows you to change the password of an existing
account.
Advertisement
Table of Contents
