Pace Commands - 3Com 3800 User Manual

Table 4-10 Port Commands
Command
config port <portlist> auto off {speed
[10 | 100]} duplex [half | full]
config port <portlist> auto off duplex
full
enable port <portlist>
enable sharing <master_port> grouping
<portlist>
enable smartredundancy <portlist>
disable port <portlist>
disable sharing <master_port>
disable smartredundancy <portlist>

PACE Commands

Table 4-11 PACE Commands
Command
enable pace
disable pace
Table 4-11 describes PACE commands.
Switch 3800 Commands
Description
Allows you to change the configuration of a group of
10/100 Mbps ports. Specify the following:
auto off — The port will not autonegotiate the
settings.
speed — The speed of the port (for 10/100 Mbps
ports only).
duplex — The duplex setting (half- or full-duplex).
Allows you to disable autonegotiation on a Gigabit
port.
Allows you to enable one or more ports.
Allows you to define a load-sharing group of ports.
The ports specified in <portlist> are grouped to the
master port.
Allows you to enable the SmartRedundancy feature on
the redundant Gigabit Ethernet port. When the
SmartRedundancy feature is enabled, the Switch
always uses the primary link when the primary link is
available. The default setting is enabled.
Allows you to disable one or more ports.
Allows you to disable a load-sharing group of ports.
Allows you to disable the SmartRedundancy feature. If
the feature is disabled, the Switch changes the main
link only when the current main link becomes
inoperable.
Description
Allows you to enable recognition of the PACE bit.
Allows you to disable recognition of the PACE bit.
4-13