Non-Hp Rack; Connecting The Cables; Nebs Chassis Ground - HP Carrier-Grade rx2800 i2 Server DC User's & Service Manual

Table of Contents

Snap the server into place.

Using the screws included in the rack kit as described in the rack kit instructions for preparing

a server for shipment, fasten the server to the rack.

Pull down the plastic retention lever on each side of the server.

Insert the screws into each side.

10. Using the instructions in the rack kit, install the cable arm.

Non-HP rack

For information on installing a server in a third party rack, see the QuickSpecs located on the HP

Integrity rx2800 i2 Server product page.

entry-class/rx2800-i2-overview.html

To view the QuickSpecs, click the HTML or PDF link under Quick Specs.

This section provides cabling information for installing the HP Carrier-Grade rx2800 i2 Server DC

Solution. This equipment is intended for installation in Network Telecommunication Facilities.

NOTE:

This carrier-grade product is intended for use in both common bonding networks and

isolated bonding networks.

Each DC power supply is provided with a power cable that has an integrated lead for implementing

the safety ground. Grounding must comply with local, national, or other applicable government

codes and regulations.

NOTE:

Terminations must be made with UL Listed compression lugs. Mating surfaces must be

cleaned to a bright metal finish and an antioxidant applied before connections are made.

Installing the server

http://h20341.www2.hp.com/integrity/us/en/

Table of Contents