01/FORK, TRIPLE CLAMP
Greasing the steering head bearing
4.11
–
Tighten screws
Guideline
Screw, bottom triple clamp
–
Repeat these steps on the opposite side.
–
Tighten nut
Guideline
Nut, steering stem
–
Position the handlebar support.
–
Mount and tighten screws
Guideline
Screw, handlebar support
300742-10
–
Position the handlebar with handlebar clamps.
–
Mount and tighten screws
Guideline
Screw, handlebar clamp
–
Position the fuel tank breather
300743-10
–
Position the brake caliper, fit and tighten the screws
Guideline
Screw, front brake caliper
300732-12
–
Position the brake line. Put the clamp on, and mount and tighten screws
–
Install the front fender. (
–
Install the start number plate. (
–
Install the front wheel. (
–
Check that the wiring harness, throttle cables and brake line have freedom of move-
ment and are routed correctly.
–
Check play of steering head bearing. (
300731-12
–
Remove the lower triple clamp. (
–
Install the lower triple clamp. (
400563-01
.
.
.
M10
.
.
M8
p. 44)
p. 44)
p. 46)
p. 18)
p. 15)
p. 16)
M6
10 Nm (7.4 lbf ft)
M20x1.5
10 Nm (7.4 lbf ft)
40 Nm
Loctite
®
(29.5 lbf ft)
M8
20 Nm
(14.8 lbf ft)
with washers.
20 Nm
Loctite
®
(14.8 lbf ft)
17
243™
243™
.