Parking Brake System; Parking Brake Pedal Or Handle Replacement - GMC G Service Manual

5A-20 HYDRAULIC BRAKES
PARKING BRAKE PEDAL OR
HANDLE REPLACEMENT
R/V and G-MODELS
M Remove or Disconnect (Figure 20)
The parking brake must be in the released position.
1. Nuts (1).
2. Release rod (3).
3. Bolt (2).
4. Brake assembly.
5. Parking brake cable (Figure 23)..
Figure 20 — Removing/installing Parking Brake
Pedal on R/V and G-Models

PARKING BRAKE SYSTEM

H Install or Connect (Figure 20)
NOTICE: For steps 2 and 4 see " Notice" on page
5A-1 of this section.
1. Parking brake cable.
2. Brake Assembly.
3. Bolt (2).
Tighten
• Bolt to "Specifications" at the end of this section.
4. Release rod (3).
5. Nuts (1).
Tighten
• Nuts (1) to "Specifications" at the end of this
section.
• Check the parking brake adjustment. Refer to "Park­
ing Brake Adjustment" in this section.
P-MODELS
H Remove or Disconnect (Figure 21)
• The parking brake must be in the released position.
1. Nuts (10) and washers (11).
2. Bolts (12) and washers (13).
3. Spacers (14).
4. Cotter pin (15) and washer (16).
5. Clevis pin (17).
6. Nut (18) and washer (19).
7. Bolt (20).
8. Spacer (21).
9. Cable (22).
10. Handle assembly.
B Install or Connect (Figure 21)
1. Handle assembly.
2. Cable (22).
3. Clevis pin (17).
4. Washer (16) and cotter pin (15).
5. Spacer (21).
6. Bolt (20).
7. Washer (19) and nut (18).
8. Spacer (14).
9. Washer (13) and bolts (12).
NOTICE: See " Notice" on page 5A-1 of this
section.
10. Washers (11) and nuts (10).
H X l Tighten
• Nuts to "Specifications" at the end of this
section.
• Check the parking brake adjustment. Refer to "Park­
ing Brake Adjustment" in this section.