TILT STEERING COLUMN BEARING
HOUSING REPLACEMENT
M
Remove or Disconnect (Figures 43
through 47)
Tools Required:
J 22635 Lock Shoe and Release Lever Pin
Remover and Installer
J 21854-01 Pivot Pin Remover
J 5822 Steering Gear Shaft Main Bearing Cup
Remover
J 2619-01 Slide Hammer
1. Negative battery cable.
2. Steering wheel. Refer to "Steering Wheel Replace
ment" in this section.
3. Turn signal switch. Refer to "Turn Signal Switch
Replacement" in this section.
• On column shift models, use a suitable size punch to
drive out the shift lever pivot and remove the shift
lever.
• Install the tilt release lever and place the column in
the "up" position.
4. Retainer (230) and spring (232). Use a screwdriver to
turn the retainer until it aligns with the grooves in the
housing, then remove the retainer and spring.
5. Upper bearing nut (253).
STEERING COLUMN 3B4-39
6. Seat (254) and race (255).
7. Housing pivot pins (221) using J 21854-01 (figure 45).
8. Bearing housing (219). Pull up on the tilt release
lever. This will disengage the shoes (224). Remove
the housing.
9. Upper and lower bearings (218 and 220).
• Remove the bearing races using J 5822 and
J 2619-01 (figure 46).
10. Tilt release lever.
11. Shoe release pivot pin (228) using J 22635 or a suit
able punch (figure 47).
12. Spring (227) and lever (229).
13. Shoe kit assembly (225).
• If the upper steering shaft, lower steering shaft, or
centering spheres are being removed, proceed as
follows:
14. Steering shaft assembly through the upper end of the
column. If it is necessary to disassemble the shaft,
proceed as follows:
• Disconnect the shaft at the pot joint coupling
clamp and remove the lower steering shaft.
• Turn the upper shaft 90 degrees to the lower
shaft and slide the upper shaft and centering
sphere from the lower shaft.
• Rotate the centering spheres 90 degrees and
remove the centering spheres and spring from
the upper shaft.