Front End Panel Replacement; Noise Shields - GMC G Service Manual

4. Vertical support to sill bolts (117).
Tighten
• Bolts to 10 N«m (7 ft. lbs.).
5. Grille. Refer to "Grille Replacement."
109. Front End Sheet Metal Cross Panel
115. Bolt
116. Sheet Metal Vertical Support
117.
Bolt
Figure 24 — Front End Sheet Metal Vertical Support
FRONT END PANEL
REPLACEMENT
B
■M Remove or Disconnect (Figure 25)
1. Headlamp bezels.
2. Grille. Refer to "Grille Replacement."
3. Front end panel to headlamp bezel support bolts
(118).
4. Front end panel to sill bolts (121).
5. Front end panel to vertical support bolts (120).
6. Front end panel from the vehicle.
E
Install or Connect (Figure 25)
1. Front end panel to the vehicle.
2. Front end panel to vertical support bolts (120).
• Assemble loosely.
3. Front end panel to sill bolts (121).
4. Front end panel to headlamp bezel support bolts
(118).
5. Grille. Refer to "Grille Replacement."
6. Headlamp bezels.
Tighten
Bolts to 18 N«m (13 ft. lbs.).
116. Sheet Metal
Vertical Support
118. Bolt
120. Bolt
Figure 25 — Front End Panel Attachment
F-00171
The G-van uses noise shields to reduce exterior engine
noise on vehicles equipped with the 6.2L diesel engine.
There are three shields on the engine compartment side of
the dash and one on the underside of the hood (figures 27
and 28).
SHEET METAL 2B-21
121. Bolt
122. Front End Panel L00505

NOISE SHIELDS