R/V Models; Hood Replacement; Spring Assembly Replacement; Hood Hinge Replacement - GMC G Service Manual

2B-2 SHEET METAL

HOOD REPLACEMENT

Remove or Disconnect (Figure 1)
B
Raise and support the hood at front and rear.
Place protective coverings over the cowl and the
fenders.
Mark the position of the hinge on the hood.
Spring assembly to hood bolts (4).
Hood hinge to hood bolts (5).
Hood from the vehicle.
B
Install or Connect (Figure 1)
. Hood to the vehicle.
1
• Align the hood with the previously made marks.
Hood hinge to hood bolts (5).
2
.
Tighten
• Bolts to 25 N*m (18 ft. lbs.).
Spring assembly to hood bolts (4).
3.
Tighten
• Bolts to 25 N«m (18 ft. lbs.).
Figure 1 — Hood Hinge Components

R/V MODELS

[<-»| Remove or Disconnect (Figure 1)
• Raise and support the front of the hood.
1. Spring assembly to hood bolts (4).
2. Spring assembly to fender bolts (1).
3. Spring assembly from the vehicle.
H Install or Connect (Figure 1)
1. Spring assembly to the vehicle.
2. Spring assembly to fender bolts (1).
• Bolts to 25 N»m (18 ft. lbs.).
3. Spring assembly to hood bolts (4).
• Bolts to 25 N*m (18 ft. lbs.).

HOOD HINGE REPLACEMENT

B
Remove or Disconnect (Figure 1)
• Raise and support the hood at front and rear.
1. Cowl vent grille. Refer to "Cowl Vent Grille
Replacement."
2. Hinge to hood bolts (5).
3. Hinge to cowl bolts (6).
4. Hinge from the vehicle.
Install or Connect (Figure 1)
1. Hinge to the vehicle.
2. Hinge to cowl bolts (6).
• Bolts to 43 N«m (32 ft. lbs.).
3. Hinge to hood bolts (5).
• Bolts to 25 N«m (18 ft. lbs.).
4. Cowl vent grille. Refer to "Cowl Vent Grille
Replacement."
SPRING ASSEMBLY
REPLACEMENT
Tighten
Tighten
Tighten
Tighten