Steering Knuckle And Arm - GMC G Service Manual

A. 2.54mm (0.10-inch)
265. Spindle
267. Bearing Seal
268. Spacer
269. Seal
270. Oil Deflector
A. Chamfer Toward
The Seal
B. Shaft Yokes
C. Universal Joint
265. Spindle
268. Spacer 269
269 Seal
270 Oil Deflector
Figure 59 — Installing the Spindle
8. Wheel hub/rotor assembly.
Refer to "Wheel Hub/Rotor Assembly" in this
e
section.
9. Wheel and tire assembly,
Lower the vehicle.
e
Figure 58 — Spindle Components

STEERING KNUCKLE AND ARM

V10/1500-20/2500 MODELS (WITH
H i Remove or Disconnect (Figures 44, 45
and 60)
• Raise the vehicle and support with suitable safety
stands.
1. Wheel and tire assembly.
2. Locking hub assembly (249).
3. Wheel hub/rotor assembly.
L00376
4. Spindle (265) from the steering knuckle (274).
5. Tie rod from the steering arm (297).
6. Nuts (295) and adapters (296).
7. Steering arm (297) from the steering knuckle (274).
8. Cotter pin (298) nuts (292 and 299).
NOTICE: Do not remove the adjusting ring (300)
unless new ball joints are being installed. If It is
necessary to loosen the ring to remove the
knuckle, do not loosen it more than two threads.
Use J 23447 (figure 60). The nonhardened
FRONT SUSPENSION 3C-53
• Refer to FRONT DRIVING AXLE (SEC. 4C).
• Refer to "Wheel Hub/Rotor Assembly" in this
section.
• Refer to "Spindle" in this section.
• Refer to STEERING LINKAGE (SEC. 3B1).
B-07465
BALL JOINTS)