Wheel Hub/Rotor Assembly - GMC G Service Manual

H O Tighten
• Nuts (170) to 28 Nvn (21 ft. lbs.).
6. Stabilizer bar (166) to the stabilizer link (116).
7. Washer (114) and nut (115).
I f f l Tighten
• Nuts (115) to 68 N*m (50 ft. lbs.).
8. Wheel and tire assembly.
• Lower the vehicle.

WHEEL HUB/ROTOR ASSEMBLY

□
Remove or Disconnect (Figures 37 and 38)
Raise the vehicle and support it with suitable safety
stands.
1. Wheel and tire assembly.
NOTICE: Support the caliper with a piece of wire
to prevent damage to the brake line.
A. Distance is 52.8 mm (2.08-inches)
114. Spacer
115. Nut
116. Stabilizer Link
117. Retainer
118. Insulator
136. Nut
Figure 41 — Stabilizer Bar Attachment Points
FRONT SUSPENSION 3C-37
2. Caliper (142).
• Refer to HYDRAULIC FOUNDATION BRAKES
(SEC. 5A2).
3. Retainer/cap (148).
4. Cotter pin (149), nut (150) and washer (151).
5. Wheel hub/rotor (154) (figures 37 and 38).
• Pull the hub/rotor free from the spindle, making
sure the outer wheel bearing (152) comes free.
• Do not damage the steering knuckle spindle
threads.
6. Inner wheel bearing (155).
• Pry out the seal (156).
7. Races.
• Drive out each race using a brass drift.
166. Stabilizer Bar
167. Insulator
168. Clamp
169. Bolt
170. Nut
171. Washer
L00588