Leaf Spring Assembly Replacement - GMC G Service Manual

H Install or Connect (Figures 7 and 8)
NOTICE: For steps 3 and 6, refer to the " iNotice"
on page 3D-1 of this section.
1. Insulators (109) to the stabilizer bar (108).
2. Stabilizer bar (108) to the anchor plates (107).
3. Clamps (110), bolts (111), washers (106), and nuts
(105).
HO
Tighten
• Nuts (105) to "Specifications" at the end of this
section.
4. Stabilizer bar (108) to the frame.
111 Important
• Route the parking brake cable over the stabi­
lizer bar.
5. Link bolt (115), washers (116), grommets (117), link
(118), retainer (119) and nut (120) (R30/3500
Models).
104. Anchor Plate
105. Nut
106. Spring Washer
107. Stabilizer Bar Anchor
108. Stabilizer Bar
109. Bushing
Figure 8 — Rear Stabilizer Attachments (P-Models)
REAR SUSPENSION 3D-9
6. Clamp (110), bolts (111), washers (106), and nuts
(105) (P30/3500 Models).
H O Tighten
• Nuts (120 and 105) to the "Specifications" at the
end of this section.
• Lower the vehicle.
LEAF SPRING ASSEMBLY
REPLACEMENT
M Remove or Disconnect (Figures 1 through 6)
• Raise the vehicle on a hoist and support the rear axle
independently to relieve tension on the leaf springs.
1. Stabilizer bar from the vehicle (if equipped).
• Refer to "Stabilizer Bar Replacement" in this
section.
2. Leaf spring (10) from the rear hanger (25).
• Loosen, but do not remove, the spring-to-
shackle nut and bolt.
110. Bracket
111. Bolt
112. Nut
113. Washer
121. Bracket
L00542