Inserting A Battery In The Single Battery Charger; Battery Charge Duration; Charge Indicators - The Led - Psion Teklogix WORKABOUT PRO M/C User Manual

8.5.1 Inserting A Battery In The Single Battery Charger

• Insert the DC power plug into the charger. Plug the pronged end of the
power cable into an AC outlet.
• Install the battery, aligning the contacts on the battery with the contacts in
the battery charge well.

8.5.2 Battery Charge Duration

It can take up to 4 hours to fully charge a battery. The single battery charger stops
applying power to the battery when it is fully charged – there is no risk of
overcharge if the battery remains in the charge well. The 75% charge indicator is
handy if you need a quick recharge – a quick charge often takes less than one hour.
8.5.3 Charge Indicators – The LED
The LED on the top of the charger indicates battery charge progress.
LED Behaviour
Off
Solid green
Fast flashing green
Slow flashing green
Solid red
Flashing red
Flashing red then green
in a 3 second cycle
Note: Battery charging continues whether the hand-held is switched on or off.

Inserting A Battery In The Single Battery Charger

No battery detected in the charge well.
Battery is fully charged.
Battery is charged to 75% capacity.
Charge in progress.
Battery is outside ambient temperature range of
0˚ C to 45 ˚C (32˚ F to 113˚ F).
Charge alarm indicating a charging circuit problem.
Refer to "Troubleshooting"
Power up test sequence.
Table 8.3 Single Battery LED Behaviour
Psion Teklogix WORKABOUT PRO Hand-Held Computer User Manual
Chapter 8: Peripheral Devices & Accessories
Charge Status
on page 151 for details.
149