Removing The Camera - Dell XPS M2010 Service Manual

Back to Contents Page
Camera
Dell™ XPS™ M2010 Service Manual

Removing the Camera

Replacing the Camera
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product
Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body
before you touch any of your computer's electronic components. You can do so by touching an unpainted metal
surface. If you leave the area, ground yourself again when you return to the computer.
NOTICE: The camera is very fragile. When servicing the camera, be careful not to grab the camera as the glass in the
camera can easily break.
Removing the Camera
NOTICE: To help prevent damage to the system board, remove the main battery before working inside the computer.
1. Follow the instructions in
2. Turn the computer over and open the display (see
3. Detach the keyboard by grasping the sides of the keyboard and pulling it straight out from the computer base. Set the
keyboard aside.
4. To access the camera, follow the instructions for removing the black display bezel and the silver display inlay (see
Removing the LCD
5. Disconnect the camera cable from the connector on the display.
6. Remove the five M2 x 3-mm screws that attach the camera and cable to the top of the display.
1 display 2
4 camera
Before Working Inside Your
Panel).
camera cable
Computer, including removing the system battery.
Opening the Display).
3 M2 x 3-mm screws (5)