5. Replace the screw (M2x3.5) that secures the wireless-card bracket to the wireless card.
Next steps
1. Install the
system-board
2. Install the
I/O
cover.
3. Install the
back
cover.
4. Install the stand.
5. Follow the procedure in
Retractable-camera assembly
Removing the retractable-camera assembly
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
back
cover.
4. Remove the
I/O
cover.
5. Remove the
system-board
About this task
The following image indicates the location of the retractable-camera assembly and provides a visual representation of the
removal procedure.
Figure 37. Removing the camera
Steps
1. Disconnect the camera cable from the system board.
2. Peel the tape that secures the camera cable to the display-assembly base.
3. Remove the two screws (M3x5) that secure the retractable-camera assembly to the display-assembly base.
4. Remove the retractable-camera assembly from the display-assembly base.
shield.
After working inside your
Before working inside your
shield.
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs)
63