Flashing The Bios - Dell XPS M2010 Service Manual

Back to Contents Page

Flashing the BIOS

Dell™ XPS™ M2010 Service Manual
NOTICE: Plug the AC adapter into a known good power source to prevent a loss of power. Failure to do so may cause
system damage.
NOTE: The Service Tag is located in the battery compartment.
1. Before flashing the BIOS, follow the instructions in
make a note the Service Tag number.
2. Ensure that the AC adapter is plugged in and that the main battery is installed properly.
NOTE: If you use a BIOS update program CD to flash the BIOS, press <F12> before inserting the CD so that you can
set up the computer to boot from a CD this one time only. Otherwise, you must enter the system setup program to
change the default boot order.
3. Insert the BIOS update program CD, and turn on the computer.
NOTICE: Do not interrupt this process once it begins. Doing so may cause system damage.
Follow the instructions that appear on the screen. The computer continues to boot and updates the new BIOS. When
the flash update is complete, the computer will automatically reboot.
4. Press <F2> during POST to enter the system setup program to update the BIOS on the new system board with the
computer Service Tag.
5. Press <Alt> and <f> to reset the computer defaults.
6. Press <Esc>, select Save changes and reboot, and press <Enter> to save configuration changes.
7. Remove the flash BIOS update program CD from the drive and restart the computer.
Back to Contents Page
Before Working Inside Your Computer to remove the battery and