Table of Contents
Advertisement
08.5
TIPS FOR THE USER
•
If condensation appears inside the stove, the causes could be:
-
The heat pump is set too low (recommended minimum threshold 60°- 65°)
-
Poor draught by the flue (clean the flue)
-
Insufficient comburent air (check comburent air conduit)
•
If the glass becomes very dirty (with visible blackening) while operating, the causes could be:
-
Low draught by the flue (clean the flue or check its characteristics)
-
Insufficient comburent air (add more air with the combustion fan, clean the air intake)
•
Check for obstructions in the flue and in the external air intake before starting the machine after a prolonged period of disuse.
•
When the stove is not used for a long period of time (spring-summer period) it is necessary to completely empty the tank, the
auger and the basket using a vacuum cleaner, then carefully clean to prevent the residual pellets from clogging and subsequently
damaging the components.
•
Every 300 kg of pellets loaded into the container, check that there are no deposits of sawdust on the bottom, and remove any
sawdust there. Sawdust reduces the auger's capacity and creates functional problems for the appliance.
•
The pellets must be fed into the hopper using a scoop. Do not empty the sack directly into the hopper.
•
The pellet hatch must be closed while the machine is running, and opened only when refuelling is necessary.
•
Prompt and systematic maintenance is a fundamental component for perfect functioning and continuous maximum heat efficiency.
•
Once a year, have the CAT clean the appliance (Technical Assistance Centre , see CHAP.08.7 - SCHEDULED PREVENTIVE
MAINTENANCE).
WARNING
The device MUST only be used with the combustion chamber door closed. NEVER open it during operations.
The safety microswitch installed on-board the machine, the alarm will be triggered if the door is opened and the device will
shutdown in 3 seconds.
MORE CLEANING = HIGHER PERFORMANCE
39
Advertisement
Table of Contents
