Table of Contents
Advertisement
07.6
HYDRAULIC KIT
The water heating stove comes with a standard pre-installed hydraulic kit without domestic hot water production (DHW)
In F
. 1 e 3 illustrate hydraulic kit component. Following is an itemised list of these components:
ig
8
9
7
10
6
5
WARNING
The installation operator is obliged to check that the closed expansion tank, supplied with the stove, has a capacity
which is suitable for the system it will be connected to. For medium/large systems, a heat technician should inspect and
calculate the needs of the rooms to be heated according to current regulations.
WARNING
1-1.2 bar cold pressurised water must always be in the stove. Topping up pressure is manual. After topping up,
make sure the valve is closed.
30
1
2
3
4
A
B
D
C
3 litre expansion tank (pre-load 1,5 bar)
1.
Heat circulation pump
2.
Anti-condensation valve
3.
Safety valve discharge ½"M
4.
System discharge ¾"M
5.
System feed* ½" M
6.
System return ¾"M
7.
System flow ¾"M
8.
9.
Outlet (pulley), to be installed facing the stove
Cut-off valve (not included, supplied by the customer)
10.
Pressure transducer
11.
Hydrometer
12.
F
. 2 illustrates the air breather unit:
ig
Air breather valve
A.
Stove water temperature probe and water safety
B.
thermostat probe well
Safety valve 3 bar
C.
11
12
Advertisement
Table of Contents
