Table of Contents
Advertisement
F
. 4
ig
F
. 6
ig
F
. 8
ig
F
. 10
ig
F
. 12
ig
F
. 14
ig
F
. 15
ig
F
. 17
ig
F
. 5
ig
F
. 7
ig
F
. 9
ig
F
. 11
ig
F
. 13
ig
F
. 16
ig
Burn pot removal for cleaning (daily)
2.
Let open the combustion chamber door and remove both the
pellet chute slide (F
. 4) and the burn pot by lifting upright (F
ig
A careful cleaning of the burning pot is required so that all holes
are duly swept.
Remove the residual ashes stacked in the burning pot overturning
them and knock off the fouling eventually formed against the internal
sides by means of a suited tool and by shaking the pot.
For an easier cleaning, it is advised to pull out the burning pot from
its casing. Clean carefully all air through holes in the pot by means
of a sharp tool.
Check that the support casing is cleaned out and the burning pot lies
in the proper casing and taking care to replace suitably the sealing
seam.
Before replacing the firebox, check there is no ash or dirt in the
firebox housing. Vacuum this area thoroughly too (F
After cleaning the burning pot make sure to replace it properly
(F
. 7).
ig
The ignition resistance has to be properly centred in the
burning pot casing and the support seat must be standing level
with the casing compartment (F
Check that the gasket located under the burning pot is correctly
placed and embedded in the apposite slot. (F
Replace also the pellet loading slide (F
Insert both strips of the pellet slide into the apposite slots, the
one located on the burning pot support surface (F
the other one next to the pellet outlet conduct (F
Once embedded, the pellet slide right side must be juxtaposed
with the right side of the combustion chamber.
3.
Ash tray removal and cleaning (daily)
Let open the combustion chamber door and pull out the tray
located under. (F
. 15-16). Once removed and emptied the
ig
tray, clear the residual ashes in its support base by means of a
vacuum cleaner. (F
. 17).
ig
Use a "drum type" vacuum cleaner equipped with a fine mesh
filter, which will simplify cleaning as it prevents the vacuumed
ash from returning to the environment. When finished, make
sure the pan is correctly reassembled.
. 5).
ig
. 6).
ig
. 8).
ig
.9)
ig
.10).
ig
.11-12) and
ig
.13-14).
ig
41
Advertisement
Table of Contents
