Control Unit Electrical Wiring Diagram - Jolly Mec I-DEA IDRO Installation, Use And Maintenance Manual

07.5

CONTROL UNIT ELECTRICAL WIRING DIAGRAM

WARNING
Electrical connections must be carried out by skilled personnel according to the regulations in force (2014/30/UE
and 2014/35/UE).
Following is a list of electrical components illustrated in the layout on the next page:
POSITION CODE
4 DEVIATRICE/1
5 RESISTENZA/6
6 CIRCOLATORE/1
11 VENT/1
12 MOTOR/17
15 TERMOSTATO/13
16 TERMOSTATO/4
18 PRESSOSTATO/2
19 MICRO/1
23 SONDA/3
24 SONDA/3
25 SONDA/3
26 SONDA/1
28 TRASDUTTORE
29 SENS/1
34 DISPLAY/11
35 DEBIMETRO/1
38 QUA/PELLET/4
39 CONNETTORE/4
40 CONNETTORE/4
41 CONNETTORE/2
42 FILTRO/1
TABLE OF COMPONENTS
Deviator value for household boiler, installation with layout 6 and 7, terminal 02.
Connection to terminal board B
Electrical resistance to start pellet burning, terminal 04
High-efficiency stove water circulator, terminal 05
Fume exhaust fan, terminal T3
Load pellet auger gearmotor, terminal T2
Stove water safety thermostat with manual reset, terminal AC2
Pellet hopper safety thermostat with manual reset, terminal AC3
Fume exhaust fan safety depressimeter, terminal AC5
Door contact safety microswitch, terminal IN9
Stove water temperature probe electrical connection, terminal IN2
Room probe electrical connection, terminal IN3. Connection also to terminal A for
external probe or thermostat connections.
Safety probe electrical connection for internal temperature inside the stove cladding,
terminal IN4
Fume temperature probe electrical connection, terminal -TC+
Stove water pressure transducer, terminal IN5
Pellet level probe, terminal IN6
Command display, DISPLAY terminal CN14
Comburent air flow probe, FLOWMETER terminal CN16
Motherboard
12-way union for probes and external devices
12-way union for probes and external devices
12-way union for ambient probes
RC filter for 3 way valve
DESCRIPTION
27