Table of Contents
Advertisement
F
. 18
ig
F
. 19
ig
F
. 21
ig
F
. 23
ig
F
. 25
ig
F
. 27
ig
42
F
.20
ig
F
. 22
ig
F
. 24
ig
F
. 26
ig
F
. 28
ig
4.
Exchanger scraping and cleaning (daily on cold device)
Pull up the cladding cover flap (F
lifting hook through the lower part of the opening door handle
(F
. 19).
ig
Move the scraper vertically (F
thorough cleaning and removal of all ash and soot from inside
the exchanger.
5.
Fume inspection cleaning (weekly)
Open the fume inspection flap (F
Loosen the locking knobs (F
ig
and remove the cap (F
. 24). Use the brush supplied to clean
ig
the ash pan (F
. 25-26) and use the ash vacuum spout to
ig
suction all the residual ash left at the bottom of the exchanger
(F
. 27) entering the inspection hatch with the ash vacuum
ig
handle.
Check that the silicone seal is fitted correctly (F
closing the inspection cap.
Put on the tap again and strengthen tight the locking knocks.
. 18) and grapple the scraper
ig
. 20) at least 5 times to ensure
ig
. 21 e 22).
ig
. 23) of the fume inspection door
. 28) when
ig
Advertisement
Table of Contents
