Stick Open-Circuit Voltage (Ocv) Selection (All Models) - Miller Dynasty 300 SD Owner's Manual

6-6. Stick Open-Circuit Voltage (OCV) Selection (All Models)

1
1 Process Switch Pad
2 Adjust Switch Pad
3 Amperage Switch Pad
4 Power Switch
To access the Stick OCV selection,
turn power switch on, press and hold
the Process, Adjust and Amperage
switch pads until software version
OM-358 Page 44
sel
lO1
And
clears the meters and [SEL] appears.
The Process Stick LED will light.
5 Encoder Control
6 Meter Display
Turn Encoder to change between low
OCV [SEL] [LO1] and normal OCV [SEL]
[LO0]. Active selection is displayed on
the meters.
6
3
V
Or
Rear Panel
When Stick low OCV is selected, open-
circuit voltage is between 9 and 14
volts. When Stick normal OCV is se-
lected, open-circuit voltage is approxi-
mately 95 volts.
Application: For most Stick applica-
tions use low open-circuit voltage. Use
normal open-circuit voltage for hard to
start Stick electrodes.
5
2
4