Troubleshooting Guide - Vitek VT-3455 User Manual

ENGLISH
PROGRAMMED PLAYBACK
You can program playback of tracks (max. 20) at
the desired order.
1. Press the CD/SD/USB button on the unit and
select the media type: disc, memory card or
USB drive.
2. Press the PROG button once. The "PROG"
symbol and the "P01" symbol will be flashing
on the LCD-display.
3. Use the FOLDER UP / FOLDER DOWN but-
tons to select the desired folder
4. Select the track by pressing the
tons.
5. To store the selected track press the PROG
button. The number of the track while pro-
gramming will change to "Р02".

TROUBLESHOOTING GUIDE

Improper usage is always the case of trouble. If you consider that there is something wrong with the
unit, check possible causes in this table.
If you have not managed to solve the problem, apply to the nearest authorized service center or to
the dealer for repair.
Problem
No sound
Improper operation of the
LCD-display
3455IM.indd 8 3455IM.indd 8
6. Repeat points 2-5 to program each of the
7. To playback the programmed tracks, press
Note: To pause the programmed playback, first
press the STOP button and then press the PLAY/
PAUSE button.
To cancel programmed playback, press the
or but-
STOP button, or open the disc slot lid, remove
a memory card or a USB from the correspond-
ing jack, or set the FUNCTION switch to another
position.
AUX IN jack
To connect the external device, use the AUX IN
jack. Connect the external device using the au-
dio cable 3,5 mm Jack - 3,5 mm Jack (not sup-
plied).
Possible cause
Zero level of volume
No power
Electrostatic electricity
8
following tracks. You can program up to 20
tracks
the PLAY/PAUSE button.
Solution
Adjust volume level
Check the power supply
Switch off the unit and switch it on
in a while
18.12.2009 17:43:16 18.12.2009 17:43:16