Troubleshooting Guide - Vitek vt-3454 bk Manual Instruction

ENGLISH
2. To cancel the random playback press the
MODE button again, the "RDM" symbols will
disappear.
PROGRAMMED PLAYBACK
You can program playback of tracks (max. 20) at
the desired order.
1. Press the CD/SD/USB button on the unit and
select the media type: disc, memory card or
USB drive.
2. Press the PROGRAM button once. The
"PROG" symbol and the "P01" symbol will be
flashing on the LCD-display.
3. Select the track by pressing the
and the +10/-10 buttons.
To cancel programmed playback, press the STOP button, or open the disc slot lid, remove a memory
card or a USB from the corresponding jack, or set the FUNCTION switch to another position.

TROUBLESHOOTING GUIDE

Improper usage is always the case of trouble. If you consider that there is something wrong with the
unit, check possible causes in this table.
If you have not managed to solve the problem, apply to the nearest authorized service center or to
the dealer for repair.
Problem
Radio
Noise while listen-
ing to radio stations
in FM or AM band
The unit does not
playback stations in
FM or AM band
3454IM.indd 8 3454IM.indd 8
/ buttons
Possible cause
The station is not tuned
FM band: the antenna is not ex-
tended
АМ band: the unit is out of reception
area
The FUNCTION switch is not set to
the RADIO position
Low volume level
4. To store the selected track press the PRO-
GRAM button. The number of the track while
programming will change to "Р02"
5. Repeat points 2-5 to program each of the
following tracks. You can program up to 20
tracks
6. To playback the programmed tracks, press
the PLAY/PAUSE button.
Note: To pause the programmed playback, first
press the PROGRAM button and then press the
PLAY/PAUSE button.
Tune the station
Extend the antenna
Try other location variants
Set the FUNCTION switch to the RA-
DIO position
Increase volume level
8
Solution
15.09.2010 16:33:19 15.09.2010 16:33:19