Power Connection - Vitek VT-3455 User Manual

ENGLISH
b) There are foreign objects inside the unit.
c) If the unit has been exposed to rain or water.
d) If the unit does not operate normally by fol-
lowing the operating instructions.
e) If the unit has been dropped or its cabinet has
been damaged.
f) When the unit exhibits a distinct change in per-
formance-this indicates a need for service.
Cleaning
Unplug this unit from the wall outlet before clean-
ing. Use a damp cloth for cleaning. Do not use
liquid cleaners or aerosol cleaners.
Cleaning discs
Do not use cracked or deformed discs, it can
damage a unit.
Hold the disc by the edges. Do not touch the sur-
face. Dust, scratches or fingerprints on the sur-
face may lead to a failure of the unit.
Protect the disc from direct sunlight; keep them
away from heat sources, high temperature and
moisture.
After usage, put the discs in the case for stor-
age.
Wipe periodically the surface of the discs with a
soft cloth from the center to the edges.
DESCRIPTION
1 –VOLUME control
2 - FUNCTION (RADIO /CD / AUX /OFF) SWITCH
3 – Carrying handle
4 – Disc slot
5 –OPEN/CLOSE button
6 – FM –antenna
7 - BAND (MW/FM) switch
8 –TUNING knob
9 – Speakers
10–MODE button
11 - Move to the previous track
12 - PLAY/PAUSE button
13 – LCD-display
14 – Move to the next track
15 –FM ST led-indicator
16 - STOP button
17 –CD/ USB /SD button
18 - SD/MMC-jack
19 - / FOLDER UP/FOLDER DOWN buttons
20 - USB flash drive jack
21 –PROG button
22 – battery compartment lid
23 –AUX IN jack
24 – Power supply jack
3455IM.indd 4 3455IM.indd 4
25 – Phones jack

POWER CONNECTION

Line supply
Before connecting the unit, make sure that your
home electricity supply corresponds to the volt-
age specified on the unit.
1. To connect the unit plug one end of the power
cord to the (24) jack and the other one – to a
socket. Set the FUNCTION switch to the CD,
RADIO or AUX position.
2. To switch off the unit set the FUNCTION switch
to the OFF position.
Note: Static electricity can lead to interfer-
ences in the operation of the unit. In this case
disconnect the unit, and then connect it again.
If the problem does not disappear, apply to the
service center.
Battery supply
1. Disconnect the cassette recorder.
2. Open the main battery compartment lid on
the rear panel of the unit, by pressing the
catches following the arrow.
3. Insert 8 "C" (UM-2) 1.5V batteries (not sup-
plied) in the battery compartment following
the polarity.
4. Close the battery compartment lid.
Attention! Battery leakage can lead to injuries
and damages of the unit. To avoid damages of
batteries follow the instructions below:
- Place the batteries properly;
- take the batteries out if you are not going to
use the unit for a long time;
- do not recharge the batteries, do not dis-
mantle them, and do not subject them to high
temperature;
- replace the batteries in time.
Note: When the unit is in the standby mode, it
4
18.12.2009 17:43:15 18.12.2009 17:43:15