Troubleshooting Guide; Specifications - Vitek VT-3474 Manual Instruction

3474.qxd 4/5/05 3:07 PM
ENGLISH

TROUBLESHOOTING GUIDE

Should this unit exhibit a problem, check the following before seeking service.
Symptom
Radio
Noise or sound distorted on AM (MW)
or FM or FM ST. broadcasts.
AM or FM or FM ST., no sound.
Cassette Player
No sound.
Sound distorted.
Speed varies.
Cassette Recorder
Will not record.
Distorted sound on playback.
Compact Disc Player
CD Player will not play.
CD skips while playing.
Disc is inserted but CD player
skips over spot and will not play.

SPECIFICATIONS

Power supply ~ 230V ~ 50Hz
DC 12V (8 x 1.5V UM2 or "C" size or LR14)
Output power 1.2Wt/per channel
Dimensions 290(W)x233(L)x150(H) mm.
Radio Settings: 20 channel presets. (FM 10, AM 10)
Frequency bands: AM 540 - 1600 kHz
Due to constant upgrading, the characteristics and
design of this product may be changed without prior
notification.
SERVICE LIFE OF THE UNIT NOT LESS 5 YEARS
GUARANTEE
Details regarding guarantee conditions can be obtained
Page 12
Possible cause
Station not tuned properly for AM (MW)
or FM or FM ST.
FM : Antenna is not extended.
AM (MW) : Unit is not positioned
correctly.
The function selector is not set to the
RADIO position.
Volume at minimum.
Function selector not set to TAPE.
Volume at minimum
Dirty head.
Tape old or worn.
Dirty roller and capstan.
Press prevention tab removed
Defective tape or dirty tape head.
Function selector not set to CD.
CD is not installed or installed
incorrectly.
Disc is dirty or scratched.
Disc inserted upside down.
Disc is dirty.
Disc is non-standard.
Cassette deck:
CD player:
Speakers
Remote control unit
FM 88 -108 MHz
from the dealer from whom the appliance was purchased.
The bill of sale or receipt must be produced when making
any claim under the terms of this guarantee.
12
Solution
Retune the AM or FM broadcast sta-
tion.
Extend FM line antenna.
Rotate unit until best reception is
obtained.
Set the function selector to RADIO.
Increase Volume.
Set the function selector to TAPE.
Increase Volume.
Clean the Record/Play head.
Replace the tape.
Clean roller and capstan.
Cover hole with tape
Replace tape or clean tape head.
Set the function selector to CD.
Insert CD with label side out.
Wipe disc with cloth or use another
disc.
Insert disc properly.
Clean disc.
Use correct disc.
Built-in ALC
Magnetic erasure
Top-loading CD
3", 8 Ohm
8 buttons, 2x "AA" batteries
This product conforms to the EMC-Requirements
as laid down by the Council Directive 89/336/EEC
and to the Low Voltage Regulation (23/73 EEC)