Download Print this page

Troubleshooting - Vitek VT-3952 DB/OG Instruction Manual

Cd/mp3 player

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Troubleshooting

Inappropriate usage often causes malfunctions and noise. If you suppose that something is wrong
with the appliance, check the possible causes of malfunction described in table below.
If you cannot fix the malfunction, apply to the nearest authorized service center or to nearest dealer
for repair.
Malfunction
No sound
LCD malfunction
Noise while listening to FM or
AM band stations
The appliance does not play
stations of FM or AM band
No disc indication/no disc
playback
Separate tracks cannot be
played back
Disk is inserted, but the
tracks cannot be played back
Delivery set:
Player –  item
Power cord –  item
Technical specifications
Power
Operation by batteries (not included in delivery set):
Player
Dimensions, mm
Output power (nominal)
Speakers
Disk loading type
CD
Frequency band
Signal/noise ratio
FM
Frequency band
Intermediate frequency
3952IM.indd 9
Possible cause
Volume level is zero
No power
Electrostatic charge
Station is not tuned
FM band: antennae is not pulled
out
AM band: the device is out of
reception area or in area of
unstable reception
RADIO mode is off
Disc playback mode is off
No disk or the disk is not installed
in correct way
CD-R is empty or it is not finalized Use finalized CD-R
There is condensation on optic
system
Disc is scratched or dirty
Disk is not inserted correctly
Disc is scratched or dirty
Inadequate disc format
AC 220 -20 V, ~50 Hz
8 batteries of R/C type
277x 207x 2 mm
,5 W х 2
2 х  W, 8 Ohm
upper
00 Hz – 0 kHz
50 dB
6 – 08 MHz
0,7 MHz
9
ENGLISH
Action
Adjust volume level
Check power source
Switch the appliance off, wait
for some time, and switch it on
again
Tune the station
Pull out antenna
Try other locations
Set operating mode switch to
RADIO position
Switch on disk playback mode
Adjust disk position, its label
should be up
Wait for some time
Wipe disc with soft cloth, do not
used damaged disks
Adjust disk position, its label
should be up
Wipe disc with soft cloth, do not
used damaged disks
Use discs of proper format
20.06.2008 11:40:03

Advertisement

loading