Troubleshooting; Cleaning The Device - Vitek VT-3478 Manual Instruction

ENGLISH
the lens
of your CD player to cloud over. Playing a CD
is then not possible. Do not attempt to clean
the lens but leave the set in a warm environ-
ment until the moisture evaporates.
• Always close the CD door to keep the CD
compartment dust-free. To clean, dust the
compartment with a soft dry cloth.
• To clean the CD, wipe in a straight line from
the centre towards the edge using a soft,
lint-free cloth. Do not use cleaning agents as
they may damage the disc.
• Never write on a CD or attach any stickers to
tapE HEad CLEaNING
The tape heads, pinch roller and capstan require
periodic cleaning. This removes particles of
the metal oxide coating that wear off the tape
and accumulate on these parts and impair
performance. Switch off the power, press the
Stop/Eject Key to open the cassette door, and
press the Play Key. Clean the tape heads, pinch
roller and capstan with a soft cloth or cotton
swab dampened in isopropyl alcohol or special
tape head cleaner.
NOTE: Never use any metal objects on or near
the tape heads. Do not allow any cleaning
material to fall into the tape assembly.

CLEaNING tHE dEVICE

• To prevent fire or electric shock hazard,
disconnect the device from the AC outlet
before cleaning.
• Clean the unit surfaces with a soft dry cloth.
Be careful when cleaning and wiping plastic
parts.
• Clean speakers surfaces with a soft dry
cloth. Do not apply wax or other polishing
spray for cleaning the speakers.
• If the front panel becomes dirty, wipe it with a
soft cloth slightly moistened with warm soap
water. Never use for cleaning any abrasives
or polishing agents, as they can damage the
Downloaded From Disc-Player.com Vitek Manuals
3478IM.indd 8
unit surfaces.
CAUTION: During cleaning, do not allow water
or other liquids to get inside the unit.

troUBLESHootING

If a fault occurs, first check the points listed be-
low before taking the set for repair.
Do not open the set as there is a risk of electric
shock.
If you are unable to remedy a problem by follow-
ing these hints, consult your dealer or service
center.
WARNING: Under no circumstances should you
try to repair the set yourself, as this will invali-
date the warranty.
No sound /power
- Volume not adjusted
• Adjust the VOLUME
- power cord not securely connected
• Connect the AC power cord properly
- Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
display does not function properly / No re-
action to operation of any of the controls
- Electrostatic discharge
• Switch off and unplug the set. Reconnect
after a few seconds
poor cassette sound quality
- Dust and dirt on the heads, etc.
• Clean deck parts etc., see Maintenance
- Use of incompatible cassette types (METAL or
CHROME)
• Only use NORMAL (IEC I) for recording
recording does not work
- Cassette tab(s) may be broken
• Apply a piece of adhesive tape over the
missing tab space
No disc indication
- No CD/MP3 inserted
• Insert a CD,MP3, CD-R.
- CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
- Laser lens steamed up
• Wait until lens has cleared
- CD-R is blank or the disc is not finalized
• Use a finalized CD-R
8
11.01.2009 14:21:25