Power Connection - Vitek vt-3454 bk Manual Instruction

ENGLISH
b) There are foreign objects inside the unit.
c) If the unit has been exposed to rain or water.
d) If the unit does not operate normally by fol-
lowing the operating instructions.
e) If the unit has been dropped or its cabinet has
been damaged.
f) When the unit exhibits a distinct change in
performance-this indicates a need for serv-
ice.
Cleaning
Unplug this unit from the wall outlet before clean-
ing. Use a damp cloth for cleaning. Do not use
liquid cleaners or aerosol cleaners.
Cleaning discs
Do not use cracked or deformed discs, it can
damage a unit.
Hold the disc by the edges. Do not touch the sur-
face. Dust, scratches or fingerprints on the sur-
face may lead to a failure of the unit.
Protect the disc from direct sunlight; keep them
away from heat sources, high temperature and
moisture.
After usage, put the discs in the case for stor-
age.
Wipe periodically the surface of the discs with a
soft cloth from the center to the edges.
Before operation
Unpack the unit. Press the OPEN /CLOSE button
and remove the protective insert before starting
to operate.
Remove all advertising labels/stickers, which
prevent the operation of the unit, from the upper
and front part of the recorder.
DESCRIPTION
1 – VOLUME control
2 – Carrying handle
3 – Disc slot
4 - OPEN/CLOSE slot
5 – FM –antenna
6 – FUNCTION (RADIO /CD / AUX /OFF)
SWITCH
7 - BAND (MW/FM ST) switch
8 – TUNING knob
9 – speakers
10 – +10 button
11 – -10 button
12 - ►║ PLAY/PAUSE button
13 – LCD-display
14 - PROGRAM button
3454IM.indd 4 3454IM.indd 4
15, 16 –FOLDER UP /FOLDER DOWN selection
button
17 - CD/ USB /SD selection button
18 – Move to the next track
19 – SD/MMC-card jack
20 - ■ STOP button
21 - USB- jack
22 - Move to the previous track
23 – MODE button
24 – Battery compartment lid
25 – AUX IN jack
26 – Phones jack
27 – Power supply jack

POWER CONNECTION

Line supply
Before connecting the unit, make sure that your
home electricity supply corresponds to the volt-
age specified on the unit.
1. To connect the unit plug one end of the power
cord to the (27) jack and the other one – to a
socket. Set the FUNCTION switch to the CD,
RADIO or AUX position.
2. To switch off the unit set the FUNCTION switch
to the OFF position.
Note: Static electricity can lead to interferences
in the operation of the unit. In this case discon-
nect the unit, and then connect it again. If the
problem does not disappear, apply to the service
center.
Battery supply
1. Disconnect the unit.
2. Open the main battery compartment lid on the
rear panel of the unit, by pressing the catches
following the arrow.
3. Insert 8 "C" (UM-2) 1.5V batteries (not sup-
plied) in the battery compartment following
the polarity.
4. Close the battery compartment lid.
Attention! Battery leakage can lead to injuries
4
15.09.2010 16:33:18 15.09.2010 16:33:18