Fantasea Moisture Detector - Fantasea Line FG9X Instruction Manual

Housing
Table of Contents

Advertisement

4. Place top flap (with logo) over bottom flap and press to close (figures #29 and #30).
5. To use, slide right hand from back side to front of the Hand Strap with knuckles protruding slightly out
of the front (lens side) of the strap (figure #29). Have it snug but not too tight, to allow for control
manipulation.
6. Always use the wrist lanyard with the hand strap.
7. When opening or closing the housing, you may need to loosen the Hand Strap slightly in
order to rotate it forward to allow for easier opening and closing of the latch.
8. When closing the housing, take special notice and care not to close part of the Hand Strap
inside the housing, which will interfere with the watertight seal of the housing.
9. Make sure to rinse the Hand Strap in fresh water and then dry after every use. Store in a dry,
shaded area.

FANTASEA MOISTURE DETECTOR

Note!
www.fantasea.com | www.canondive.com
Figure #29
Never soak or wash the interior of the housing with water. This will set off
the alarm in a way that cannot be disabled, eventually causing irreparable
damage to the electronic unit!
The moisture detector is a bonus add-on component and not an integral
part of the housing. Accordingly, it is not part of the housing warranty
coverage. The moisture detector has no warranty coverage.
FG9X Housing Instruction Manual 20160409
31
Figure #30

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents