Fantasea Line FG9X Instruction Manual page 15

Figure #2 Figure #3
e. Install the anti-glare hood over the anti-
glare hood rails at the back of the
housing. First install the anti-glare hood
over the top rail starting from the left
corner (figure #4), gently inserting it
between the top rail and the Flash Pop-
Up switch until it is properly seated on
the rail. Carefully stretch it to the right
so it is completely installed on the top
rail. Then stretch the anti-glare hood
Figure #4
downwards to install it on the bottom
rail, eventually making sure it's sitting securely on both upper and lower rails. This can be
verified by looking at the housing from the left side and ensuring that the anti-glare hood
is close fitted to the housing with a noticeable space between the anti-glare hood and
the Flash Pop-Up switch on top of it (figure #5). Note that failure to properly install the
anti-glare hood on the top rail might result with inability to rotate the Flash Pop-Up
switch on top of the anti-glare hood.
Figure #5
FG9X Housing Instruction Manual 20160409
www.fantasea.com | www.canondive.com 15