Identification Of Parts; Silencing The Alarm - Fantasea Line FG9X Instruction Manual

The alarm unit of the Moisture Detector is installed inside the
housing, opposite the latch dial (figure #31 – item A). The Moisture
Sensor unit is installed just under the camera (figure #31 – item B).
A thin wire connects these units. Moisture detectors are very
sensitive, so whenever moisture is detected by the sensor, the
moisture detector LED light begins flashing and a warning alarm
starts beeping, thereby alerting the user of a possible leak.

IDENTIFICATION OF PARTS

Electrical wires
Electrical plug
Wrapped Alarm Unit

SILENCING THE ALARM

1. In order to silence the alarm after it goes off, wipe the Moisture Sensor unit at the bottom of the
housing gently with a soft dry cloth in order to dry it off.
2. If this doesn't help, remove the alarm unit from the housing by gently sliding it out of its slot
(figure #32 on the following page).
3. Expose the white electrical plug under the black tape wrap (figure #33 on the following page).
4. Disconnect the electrical wires plug from the alarm unit socket.
www.fantasea.com | www.canondive.com
Black tape wrap
Sound
Alarm
Cylinder
Red LED light
Battery
compartment
Battery removal
Unwrapped Alarm Unit
groove
Moisture Sensor Unit
FG9X Housing Instruction Manual 20160409
32
A
B
Figure #31
3V Lithium
#CR1220 Battery
Sensor