Scheduled Conference Calls (Meet Me); Host A Meet Me Conference; Join A Meet Me Conference; Intercom Calls - Cisco 8811 User Manual

Calls

Scheduled Conference Calls (Meet Me)

You can host or join a conference call at a scheduled time.
The conference call does not start until the host dials in and ends when all participants hang up. The conference
does not automatically end when the host hangs up.

Host a Meet Me Conference

Before You Begin
Get a meet me phone number from your administrator, and distribute the number to the conference participants.
Procedure
Step 1
Lift the handset to get a dial tone and press Meet Me.
Step 2 Dial the meet me phone number.

Join a Meet Me Conference

You cannot join a meet me conference until the conference hosts dials in. If you hear a busy tone, the host
has not dialed into the conference. Hang up and try your call again.
Procedure
Dial the meet me phone number that the conference host provides.

Intercom Calls

You can place and receive one-way calls using an intercom line.
When you place an intercom call, the recipient's phone answers the call automatically with mute activated
(whisper mode).Your message is broadcast through the recipient's speakerphone, headset, or handset, if one
of these devices is active.
After receiving the intercom call, the recipient can start two-way audio (connected mode) to allow for further
conversation.

Make an Intercom Call

When you place an intercom call, your phone enters whisper mode until the recipient accepts the intercom
call. In whisper mode, the other person can hear you, but you can't hear them. If you are on an active call, that
call is placed on hold.
Scheduled Conference Calls (Meet Me)
Cisco IP Phone 8800 Series User Guide
37