I2C Commands; Oem Ipmi Commands To Get Ethernet Hard Drive Information; Standards - Supermicro K1048-RT User Manual

K1048-RT Microserver User's Manual

I2C Commands

Below are the Opcodes I2C commands that you can use.
OEM IPMI Commands to Get Ethernet Hard Drive
Information
To get Ethernet hard drive information, use the following information to get OEM
IPMI commands.
Note: Only a subset of opcode is supported within the Ethernet interface
specifi cation. Please see manufacturer specifi cations.

Standards

BMC IP address by default is set to static: 192.168.1.99
Username: ADMIN
Password: ADMIN
ipmitool -U ADMIN –P ADMIN –H 192.168.1.99 raw 0x30 0x70 0x86 drive_number
I2C Commands
Opcode Name
0x02 Get Manufacturer
0x03 Get Product ID
0x05 Identify Device
0x06 Get Device Temperature
0x08 Get Device IP Address
0x09 Set Device Network Speed
0x0a Get Device Network Speed
0x0c Enable External Loopback
0x0e Get Command Set Version
0x0f Disable External Loopback
0x10 Reset Device
0x12 Set Device IP Address
0x13 Get Device Network MAC
0x14 Get Interface Link State
0x15 Get Firmware Version
0x16 Get Data Protocol Version
B-2