Table of Contents
Advertisement
Replacing a Hard Drive
This procedure may be performed while the system is operating (hot-replacement)
extra caution should be taken when replacing drives near the high speed fans (drive
bays 9, 10, 11 and 12).
1. Remove front/HDD cover from the chassis (Figure 6-2).
2. Locate and press the latch down on the HDD you wish to remove from the
chassis (Figure 6-3 and Figure 6-4).
3. Disconnect the drive connection from the HDD. Note the number on the fl oor
of the chassis.
4. Remove the metal tray from the dead drive and install it on the replacement
drive.
5. Connect the drive cable and gently push it down onto the mounting bracket
until it clicks into position.
3.5" HDD
Latch
Figure 6-4. Replacing HDDs
6-5
Chapter 6: Advanced Chassis Setup
Backplanes
Advertisement
Table of Contents
