Table of Contents
Advertisement
Onboard Controllers/Ports
The K1048-RT system contains the following I/O ports: four 10G Ethernet ports and
one IPMI LAN. The system's mainboard supports up to twelve (12) Ethernet drives.
Note: The default IP Address for the system is 192.168.1.99.
Other Features
Other onboard features for the system include the following:
•
Redundant I2C connection for status/polling of media
•
Controls to optimize power utilization
•
Out of band system management with IPMI 2.0 GUI or ipmitools software
•
Persistent drive bay position/enumeration
•
HDD IP address assignment (DHCP is default)
For details on IPMI software and resources go to the SuperMicro webiste at
supermicro.com
cfm
for more details.
1-3
Server Chassis Features
The following is a general outline of the main features of the SC801 server chassis.
System Power
Each SC801 chassis model includes a high-effi ciency 94% or 95+% Platinum
certifi ed power supply, rated at 400 Watts plus one redundant backup power supply.
In the unlikely event your power supply fails, replacement is simple and can be
accomplished without tools.
Note: The power supplies are both redundant, hot-plug.
Microserver Disk Subsystem
The SC801 features twelve (12) 3.5" Ethernet drives mounted in the chassis. These
drives are hot-swappable units and are connected to the system by cables that
provide power and dual-ported Ethernet access. By default the drives are confi gured
for DHCP (two addresses, one per port). Static assignment is supported through
the IPMI interface.
or see
http://www.supermicro.com/solutions/ManagementSoftware.
1-3
Chapter 1: Introduction
www.
Advertisement
Table of Contents
