Starter - Buell 2005 P3 Service Manual

HOME

STARTER

REMOVAL
1. Remove seat. See 2.28
1 1
WARNING WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect negative (-)
battery cable before proceeding. (00048a)
1 1
WARNING WARNING
Disconnect negative (-) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00049a)
2. Disconnect battery cables from battery, negative cable
first.
3. Remove air cleaner. See
4. Remove left side footpeg support bracket and primary
cover. See 2.21 FOOTPEGS AND FOOTPEG SUP-
PORT BRACKETS.
7767
1. Locknut
2. Clamp
Figure 5-9. Oil Hose Clamp
5. See Figure 5-9. Remove locknut and clamp that secure
oil hoses on right side of motorcycle.
6. Push hoses to either side to allow access to starter.
SEAT.
1.18 AIR CLEANER.
1
2
7766
Figure 5-10. Starter Mounting Bolts and Washers
(Primary Side)
7. See Figure 5-10. Remove both starter mounting bolts
and washers.
NOTE
A ball hex driver may be required to gain access to the starter
mounting bolts.
7768
1. Positive battery ring terminal
2. Connector [128]
Figure 5-11. Starter Wires
8. See Figure 5-11. Remove positive battery cable from
solenoid.
a. Remove protective boot if present.
b. Remove nut with washer (metric) that attaches posi-
tive battery cable to post.
c. Remove positive battery cable ring terminal.
d. Detach solenoid connector [128].
e. Remove starter and gasket.
2005 Buell P3: Electric Starter
5.7
2
1
5-11