Buell 2005 P3 Service Manual page 315

HOME
INSTALLATION
Primary Chain Adjuster
1. See Figure 6-3. If shoe is badly worn, replace it.
2. Install chain tensioner spring over pin and into hole in
crankcase.
3. While prying the tensioner spring down, slide shoe onto
pin and tensioner spring.
4. Press shoe inward.
5. Install primary cover. See
MARY CHAIN.
Primary Chain Adjustment
See Figure 6-4. Buell Blast Models are shipped with a spacer
between the primary chain limiting screw and the locknut. The
spacer is used to quickly get proper adjustment during pro-
duction. This spacer should be removed and discarded at the
first adjustment interval.
7790
3
1. Chain limiting screw
2. Spacer
3. Jam nut
Figure 6-4. Adjustment Nut-with Spacer
Primary Cover in 6.2 PRI-
2
1
7789
Figure 6-5. Chain Limiting Screw-without Spacer
1. See Figure 6-5. Back-off locknut and chain limiting
screw. Remove spacer.
IMPORTANT NOTE
Be certain to use Inch-Pound Wrench. Chain adjuster shoe
can be damaged by excessive force.
7791
Figure 6-6. Torquing Chain Limiting Screw
2. See Figure 6-6. Tighten chain limiting screw to 24 in-lbs
(2.7 Nm).
3. Back-off chain limiting screw 3/4 turn (4 1/2 "flats").
4. Hold chain limiting screw while tightening jam nut.
2005 Buell P3: Drive/Transmission 6-5