Alternator - Buell 2005 P3 Service Manual

HOME

ALTERNATOR

REMOVAL/DISASSEMBLY
1. Remove seat. See 2.28
11 1
WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect negative (-)
battery cable before proceeding. (00048a)
2. Disconnect negative battery cable from battery.
3. Remove primary cover. See
4. Remove clutch assembly, primary chain and engine
sprocket/rotor assembly as a unit. See
DRIVE/CLUTCH.
5. Remove/disassemble rotor and/or stator, as required.
Refer to the following procedures.
Rotor
1. See Figure 7-52. Remove the eight bolts which secure
alternator rotor to engine sprocket.
7805
Figure 7-52. Rotor Assembly
7-40 2005 Buell P3: Electrical
SEAT.
WARNING
6.2 PRIMARY CHAIN.
6.4 PRIMARY
7806
4
1. Arbor press
2. Rotor
3. Sprocket
4. Blocking
Figure 7-53. Removing Rotor From Sprocket
2. See Figure 7-53. Position blocking under rotor. Press
sprocket free of rotor.
NOTE
Resistance to sprocket/rotor disassembly is due in part to the
magnetic force of the permanent rotor magnets.
7.14
1
2
3