Buell 2005 P3 Service Manual page 151

HOME
3788
Figure 2-91. Install New Dust Seal
16. See Figure 2-91. Install new dust seal onto slide pipe.
3781
Figure 2-92. Remove Slider Tube Protection
17. See Figure 2-92. Remove the tape from the slider tube
end.
NOTE
The recommended fork oil is hydraulic fork oil type "E".
18. Pour 9.2 oz. (272 ml) fork oil into fork.
19. Install lower spring joint and spring collar.
20. Coat a new o-ring with fork oil or sealing grease.
21. Install new o-ring onto spring seat.
2-52 2005 Buell P3: Chassis
3769
Figure 2-93. Compressing Spring Seat to Install
Stopper Ring
22. See Figure 2-93. Push down on spring seat past groove
to install stopper ring. Stopper ring will lock into groove
when installed correctly.
3768
Figure 2-94. Slider Tube Cap
23. See Figure 2-94. Install slider tube cap.
24. See Figure 2-95. Install fork assemblies through upper
and lower triple clamps.